Over time, the conditions the product is exposed to cause the outer layer to fade. The resulting product looks chalky and also dull. Nevertheless, this situation can be quickly fixed. You should start the restoration process by cleaning the surface. If you can get hot water then you should use it in this process. A sponge for scrubbing is also needed. Ensure you have a detergent. Some of them are corrosive and you ought to use protective gear.
If mildew is present, bleach will have to be utilized in the cleaning process. Additionally, concentrated cleaning formulation should be used when stubborn stains are present. The surface should be rinsed with clean water so that all the detergent present is washed away. Thereafter, allow the item to dry off. If you are in a hurry, you can dry it manually.
For better results, all oil should be removed from the item. Not all detergents succeed in accomplishing this. Acetone or MEK should be used for this purpose. However, it is advisable to use a microfiber cloth to apply it. Direct application is discouraged. You may need several of them because you have to discard it once they are covered up with grease. The next step is to wax the item. This can prolong its life.
The procedure of applying wax differs depending on the manufacturer. Therefore, you have to read the instructions given. Nevertheless, a foam pad or cloth is used in applying the wax. Proceed in circular motions. After the wax has dried, you should buff the excess using a soft piece of cloth.
The next step is polishing. This should be done using an abrasive. Fine sandpaper is preferred. It will remove pitted areas. This is not something you can achieve with coating. You should tackle a small section at a time. In addition, the motions have to be circular. Go on until you can see your reflection on the surface. An extra layer of wax should be added after you are done polishing for protection. Some preparations contain wax in the formulation.
Some items are so worn out such that polishing alone cannot restore then to their original state. However, all you need is a strong abrasive. Any wax on the fiberglass should be eliminated before the polishing begins. If you do not do this, you will have uneven surface. Do not go forth and back but rather straight while doing this. Toluene or any other solution which can remove the wax can be utilized.
A restorer should be applied last. There are a lot of them meaning you will not have a difficult time shopping for one. They work almost the same as wax. Nonetheless, buffing is recommended after the restorer has being applied. You will be impressed with the results. However, remember that the item will not retain the new look forever. However, it will last for some time if you take care of it well.
About the Author:
If you like this article please shere it